![]() Mount controller anywhere in cabin (this is important for ease of accessibility in the event of unforseen failure).This spacer is not supplied with the kit. Note: If the actuator for rear window is mounted partly on the strut bracket a spacer should be placed under the actuator of the same thickness of the strut bracket. Repeat steps 1 & 2 for all 5 other locking positions (next to handles).The bracket can also be bent up or down to ensure actuator pin engages with the bracket when locked and clears the bracket when unlocked The hole in the bracket may need to be enlarged to ensure that the pin moves freely with the window handle in the open or closed position, this can be done by using a file to make the hole larger. Next loosen off the actuator screws so spacer can be placed in between the actuator and the window frame, (side windows only) use a small amount of silicone to keep spacer in place then retighten screws so actuator is firmly secured to window frame. ![]() Secure the actuator to the window frame using 2 of the 8g x 12 screws. Now push the pin of the actuator fully down to make sure top of pin clears the bracket so window can be opened. Where window bracket is now installed place the actuator on the inside of the window frame with the pin extended upwards and line up the pin to the centre of the hole in the bracket and the shoulder on the pin to the underside of the bracket.Push one of the black plastic caps over the outside end of the bracket. When the bottom of the bracket is touching the window, push double sided tape onto the window to secure bracket. (it is recommended to mark the positions of all the brackets and then clean all positions so wipe does not dry out)Then peel plastic from double sided tape on bracket and slide bracket over bottom of window (without the tape touching the window). Select location for window bracket (close to handle but leave enough room so as not to interfere with movement of the handle, and making allowance for protection bracket to be installed) Use VHB wipe to clean window where bracket is to be fitted. Install 4 bolts straight through the bottom of the canopy and the top of the styleside to get a decent fix.Ī day spent on the canopy now in preparation of a big trip will repay you on the track.Installation:(Note if you are unsure of these steps please refer to the picture gallery at - most steps are shown) The fix we came up with in the Alice Springs caravan park which stayed the same way until I sold the ute was to wind up the adjustment to where we were happy, drill a hole through the threaded rod, and install a split pin, bolt, nail, wire through the hole.Īlso, if you are relying on the pop riveted tie downs, they are a complete waste on time. Note also if you have the flexiglass tradesman's racks and internal frame, the adjuster thread with the nut WILL undo itself on corrugations, leading to the legs spreading and the Colorado styleside cracking - ask me how I know haha. I'd also do the inside of the whole of the bottom of the canopy where it strikes the ute the same way. If you aren't confident, get someone to help because it makes a good mess if not done well. Prep the ally/fibreglass junction with alcohol and install either sika-pro or 11fc into the rear of the frame, inside and out. My guess, having had a few flexiglass canopies is that it will be leaking past the window frame, not the window seal.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |